QuickPlate & Low Taper Collet the solution to "smooth riding vehicles"
For the tyre/rim assembly to be balanced through 360 degrees it has to be mounted to the wheel balancer on the same axis (x-axis) as it is fitted on the vehicle.
If it is not balanced correctly there will be a vibration. Mount the wheel on the wheel balancer just like the wheel is mounted on the vehicles hub (mirror image mounting).
The simulates the hub of the vehicle, x-axis alignment (center of wheel). The QuickPlate simulates the wheel nuts.
The Wing nut provides the equal torque to each stud on the QuickPlate y-axis alignment (perpendicular to hub).
QUICKPLATE SYSTEM- NEW Series V
QPK 400 407
3 x QuickPlate 4, 5, 6 without caps
6 x short taper caps 80mm
6 x long taper caps 100mm
6 x long taper caps narrow 100mm
5 x rounded head caps 90mm
5 x range/land rover caps 80mm
1 x 4x4 rear con mounting kit
1 x adaptor board.
suits Wheel Balancers with 40mm diameter shaft:
including BEISSBARTH/SICAM/BOSCH, EAGLE- MONDOLFO,HUNTER, COATS, CORGHI/HPA-FAIP/TECO, CEMB/HOFMAN MEGAPLAN/RAV, FASEP.
QUICKPLATE CAPS
HOW TO MEASURE TOTAL LENGTH OF THE STUD
Base section is 42mm long. Add the length of the stud cap
273e008 025 Long Taper 58mm x 24,5mm complete length 100mm
273e008 003 Short Taper 38mm x 24,5mm complete length 80mm
273e008 023 Narrow Taper 55,6mm x 22,5mm complete length 97.6mm
273e008 007 Round head 48mm x 24,5mm complete length 90mm
QUICKPLATE 4 # 249 012 400
QUICKPLATE 5 # 259 012 400
QUICKPLATE 6 # 269 012 400
Spare part
# 200e008 027eccentric ring for series IV QuickPlates
The Low Taper Collet's have a 3 degree taper to slide easily into the center bore of the wheel. Both sides of the collet are usable so that 9 collets cover cars, SUV's and 4x4 vehicles.
Used in combination with the QuickPlate the tyre and rim assembly are balanced though 360 degrees.
QuickPlate & Low Taper Collet the solution to "smooth riding vehicles"
a = QuickPlate cap simulating the wheel nut
b = Low taper collet simulating the hub of the vehicle
